MIL-STD-100 Engineering Drawings S/S By Asme-Y14.100, Asme-Y14.24, Asme-Y14.35M, And Asme-14.34MThis standard, along with ASME Y14.100M, establishes the essential requirements and reference documents applicable to the preparation and revision of engineering drawings and associated lists for or by Departments and Agencies of the Department of Defense. ASME Y14.100M is the preferred requirements document for engineering drawing practices. This standard should only be used in lieu of ASME Y14.100M where the necessity for a DoD design activity is fully justified and Government logistics support is required

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78 - 79 - 80 - 81 - 82 - 83 - 84

MIL-STD-1OOG

agencies. The DRPRG addresses the entire range of issues from the current status and needed changes to MIL-STD-100, to electronic data storage and transmission, and the ongoing

requirement for compatibility with initiatives associated with Continuous Acquisition and Life Cycle

Support (CALS).

7. The DRPRG is chaired by the DOD Lead Standardization Activity (LSA) for DRPR and is co- chaired by an industry association member. The Office of the Assistant Secretary of Defense for Production and Logistics provides management oversight through its representative who serves as Executive Liaison. The DRPRG meets three or four times a year to address issues brought before it. For more information on the DRPRG and its proceedings please contact the DRPR LSA, located at the address indicated above for beneficial comments.

iii