MIL-STD-100 Engineering Drawings S/S By Asme-Y14.100, Asme-Y14.24, Asme-Y14.35M, And Asme-14.34MThis standard, along with ASME Y14.100M, establishes the essential requirements and reference documents applicable to the preparation and revision of engineering drawings and associated lists for or by Departments and Agencies of the Department of Defense. ASME Y14.100M is the preferred requirements document for engineering drawing practices. This standard should only be used in lieu of ASME Y14.100M where the necessity for a DoD design activity is fully justified and Government logistics support is required

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78 - 79 - 80 - 81 - 82 - 83 - 84

MIL-STD-1OOG

It is essential to drawing interpretation that past versions of MIL-STD-100 that were contractually invoked for the delivery of drawings continue to apply, and that no drawing under the CAGE Code of a Government design activity be interpreted under or make direct, sole reference to ASME Y14.100M.

6.7  Reference to non-Government standards.  Very broad areas of the subject matter of MIL- STD-100 have been replaced by or incorporated in to non-Government Standards (NGSs).  Every effort was made to harmonize the technical content and availability of the applicable NGSs to the requirements contained herein.  However, users of Revision G to MIL-STD-100, especially

during the earliest stages of initial issue, may find that the apparent corresponding NGS is not yet available or fails to support basic document preparation requirements.  In order to overcome this condition in satisfying a contractual intent, or document preparation requirement or associated practice, the user should be prepared to detail the needed engineering drawing practice directly in the statement of work.  Past issues of MIL-STD-100 may be used in attempting to establish the needed detail for entry in the statement of work.

6.8  Subject term (key word) listing.

Acronym Altered item Assembly Associated list Bulk item CAGE Code

Contract number Critical safety Design activity Diagram

Digital data Dimensioning Distribution Statement Drawing number

Electrostatic Discharge Sensitive

Item identification

Notes

Nuclear hardness

Part or identifying number

Parts list

Product definition data

Qualification

Vendor item control

6.9  Changes from previous issue.  Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes.

25