MIL-STD-100 Engineering Drawings S/S By Asme-Y14.100, Asme-Y14.24, Asme-Y14.35M, And Asme-14.34MThis standard, along with ASME Y14.100M, establishes the essential requirements and reference documents applicable to the preparation and revision of engineering drawings and associated lists for or by Departments and Agencies of the Department of Defense. ASME Y14.100M is the preferred requirements document for engineering drawing practices. This standard should only be used in lieu of ASME Y14.100M where the necessity for a DoD design activity is fully justified and Government logistics support is required

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78 - 79 - 80 - 81 - 82 - 83 - 84

MIL-STD-1OOG

.

FIGURE 400-2.  Example of drawing notation when design responsibility is transferred.

406.10  Item identification and PIN.  Each item shall be identified as follows:

a.  Design activity items shall be assigned PINs that meet the requirements of 406.6.

b.  When several items are detailed on a single drawing by tabulation, or through multi-detail, detail assembly, or installation drawing, each item shall be assigned a separate PIN meeting the requirements of 406.6.

c.  Altered and selected items shall be assigned a PIN meeting the requirements of 406.6.

d.  Source control items shall be assigned a PIN meeting the requirements of 406.6. See Note

1.

e.  The PIN for an item delineated on a vendor item control drawing shall be the part number

assigned by the vendor.  However, reference to the items depicted shall be to an administrative control number established by the vendor item control drawing and, as applicable, suffix identifiers.    Administrative control numbers shall have the same requirements as a PIN. See Note

2.

f.  When interchangeable items are repairable, but the repair parts are not interchangeable, each item shall be assigned a separate PIN.

NOTE 1: Source control drawing numbers along with applicable suffixes establish PINs. When more than one vendor is listed on a source control drawing for items that are repairable and the

42