MIL-STD-100 Engineering Drawings S/S By Asme-Y14.100, Asme-Y14.24, Asme-Y14.35M, And Asme-14.34MThis standard, along with ASME Y14.100M, establishes the essential requirements and reference documents applicable to the preparation and revision of engineering drawings and associated lists for or by Departments and Agencies of the Department of Defense. ASME Y14.100M is the preferred requirements document for engineering drawing practices. This standard should only be used in lieu of ASME Y14.100M where the necessity for a DoD design activity is fully justified and Government logistics support is required

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78 - 79 - 80 - 81 - 82 - 83 - 84

MIL-STD-1OOG

APPENDIX A

SECURITY CLASSIFICATION MARKINGS AND NOTATIONS

A10.  GENERAL.

A10.1  Scope.  This Appendix is intended to provide direction concerning the marking of security classifications and related notations on drawings.  This Appendix is a mandatory part of this standard.  The information contained herein is intended for compliance.

A20.  APPLICABLE DOCUMENTS. A20.1  Government documents.

A20.1.1  Other Government documents.  The following other Government documents form a part of this Appendix to the extent specified herein.  Unless otherwise specified, the issues are those cited in the solicitation.

DOD 5220.22-M - DoD Industrial Security Manual for

Safeguarding Classified Information

(Copies of DoD 5220.22-M are available from the Superintendant of Documents, U. S. Government Printing Office. Washington, DC  20402-0001)

A30.  DEFINITIONS.  This Section is not applicable to this Appendix.

A40.  GENERAL REQUIREMENTS.

A40.1  Security classifications and notations.  Location of espionage, special security and regrading notes such as the sample classifications in Figure A-1, shall be in accordance with DoD

5220.22-M, and Command Security and Local Security requirements, and the direction contained herein.

A40.1.1  Assigning classification.  Security classification on drawings and associated lists shall be consistent with project or program classification.  Classification of associated lists shall be based on the content of the lists and not on the classification of the drawing.

A40.1.2  Application of security classification.  Security classification markings may be generated from digital data, applied by decals, rubber stamps or by lettering template. Markings shall meet the reproduction requirements of the drawing or list.

A40.1.3  Size of security markings. Security markings shall be larger than any other marking or lettering size on the drawing or associated list.

A40.1.4  Color of security markings. All security classifications and notations shall be black.

48