MIL-STD-100 Engineering Drawings S/S By Asme-Y14.100, Asme-Y14.24, Asme-Y14.35M, And Asme-14.34MThis standard, along with ASME Y14.100M, establishes the essential requirements and reference documents applicable to the preparation and revision of engineering drawings and associated lists for or by Departments and Agencies of the Department of Defense. ASME Y14.100M is the preferred requirements document for engineering drawing practices. This standard should only be used in lieu of ASME Y14.100M where the necessity for a DoD design activity is fully justified and Government logistics support is required

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78 - 79 - 80 - 81 - 82 - 83 - 84

MIL-STD-1OOG

Drawing Number: Title:

Notification is herewith given that the following vendor was removed from (drawing number)

on (date).

(Name of Government Representative) (Title of Government Representative) (Name of Government Installation) (Address of Government Installation)

BS0.12  Foreign manufacturers.  If the manufacturer is of foreign origin, the letter of notification of qualification will state that acquisition will be subject to all official agreements made by the Government, laws, and policies affecting acquisition of foreign-made products, in addition to the requirements of B50.3.  Testing of products from foreign sources shall take place at a facility in the U.S. that is satisfactory to the design activity.

BS0.12.1  Reciprocal qualification agreements.  The recognizing of foreign products through reciprocal agreements between various countries, in lieu of actual qualification, does not apply to the process of approving sources of supply to control drawings

66